APRS Track Direct

My position About ☰

reset

DTSERO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DTSERO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1749328618	128	0	47	42	49
1749328012	136	29	64	41	48
1749327410	135	29	63	41	48
1749326807	135	26	64	41	48
1749324987	134	68	60	41	49
1749324379	136	29	63	41	49
1749323769	136	39	63	41	49
1749323156	137	29	66	65	49
1749322557	137	25	67	41	49
1749321955	136	25	64	41	48
1749321349	137	29	65	66	49
1749320745	137	26	90	42	75
1749319533	135	27	63	42	48
1749318923	137	29	65	41	74
1749318317	137	25	65	66	49
1749317703	135	31	64	66	49
1749317101	137	28	66	41	48
1749316500	135	28	63	42	48
1749315893	142	29	63	41	48
1749315284	135	28	64	64	49
1749314671	143	27	93	42	48
1749314057	140	29	93	41	74
1749313447	140	37	64	41	74
1749312837	142	27	65	41	48
1749311620	142	25	92	41	77

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)