APRS Track Direct

My position About ☰

reset

OK0BAD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0BAD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Vin*	Rx1h*	Dg1h*	Eff1h*	T_ext*
1758196876	105	59	124	15	82
1758195975	105	67	123	15	82
1758195075	105	58	123	15	82
1758194175	89	54	123	15	82
1758193276	95	53	123	15	82
1758192375	96	59	124	15	82
1758191475	96	58	124	15	82
1758190575	99	60	124	15	82
1758189676	105	60	124	15	82
1758188776	101	64	124	15	82
1758187876	106	60	124	15	82
1758186975	108	64	124	15	82
1758186076	106	62	123	14	82
1758185176	108	64	123	14	82
1758184276	105	59	123	14	82
1758183375	104	59	123	14	82
1758182476	104	59	123	14	82
1758181576	103	61	122	14	82
1758180676	106	58	122	14	82
1758179775	103	55	122	14	82
1758178876	108	58	122	14	82
1758177976	97	53	122	14	82
1758177076	99	50	123	14	90
1758176176	105	61	123	14	90
1758175277	100	54	123	14	90

*Used Equation Coefficients:

Vin: 0, 1, 0

Rx1h: 0, 1, 0

Dg1h: 0, 1, 0

Eff1h: 0, 1, 0

T_ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)