APRS Track Direct

My position About ☰

reset

eb1ayw-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object eb1ayw-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1786739808	-59 dbm	2.94 V
1786739208	-65 dbm	2.94 V
1786738608	-57 dbm	2.94 V
1786738008	-63 dbm	2.94 V
1786737408	-64 dbm	2.94 V
1786736808	-59 dbm	2.94 V
1786736208	-60 dbm	2.94 V
1786735608	-52 dbm	2.94 V
1786735008	-64 dbm	2.94 V
1786734408	-60 dbm	2.94 V
1786733808	-61 dbm	2.94 V
1786733208	-61 dbm	2.94 V
1786732608	-62 dbm	2.94 V
1786732008	-62 dbm	2.94 V
1786731408	-58 dbm	2.94 V
1786730808	-62 dbm	2.94 V
1786730208	-66 dbm	2.94 V
1786729608	-60 dbm	2.94 V
1786729008	-67 dbm	2.94 V
1786728408	-65 dbm	2.94 V
1786727808	-64 dbm	2.94 V
1786727208	-66 dbm	2.94 V
1786726608	-62 dbm	2.94 V
1786726008	-59 dbm	2.94 V
1786725408	-61 dbm	2.94 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)