APRS Track Direct

My position About ☰

reset

E27ASY-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E27ASY-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RxTraffic*	TxTraffic*	RxDrop*	RSSI*	Voltage*
1732429298	95 Pkt	0 Pkt	0 Pkt	-58 dBm	14.97 V
1732428054	34 Pkt	0 Pkt	0 Pkt	-58 dBm	15.03 V
1732426823	23 Pkt	0 Pkt	0 Pkt	-58 dBm	15.03 V
1732425594	48 Pkt	0 Pkt	0 Pkt	-58 dBm	15.03 V
1732424358	77 Pkt	2 Pkt	2 Pkt	-58 dBm	15.03 V
1732423118	31 Pkt	0 Pkt	0 Pkt	-56 dBm	14.95 V
1732421887	-	-	-	-	-
1732421886	84 Pkt	0 Pkt	0 Pkt	-55 dBm	15.03 V
1732420647	121 Pkt	0 Pkt	0 Pkt	-57 dBm	15.03 V
1732419403	67 Pkt	0 Pkt	0 Pkt	-52 dBm	14.95 V
1732418164	107 Pkt	0 Pkt	0 Pkt	-57 dBm	14.97 V
1732416918	25 Pkt	0 Pkt	0 Pkt	-56 dBm	14.97 V
1732415688	31 Pkt	0 Pkt	0 Pkt	-55 dBm	14.97 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)