APRS Track Direct

My position About ☰

reset

ZL2PO-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL2PO-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732290846	132	113	255	72	56
1732289645	132	113	255	72	56
1732288444	132	113	255	72	56
1732287243	132	114	255	71	56
1732286042	132	114	255	71	56
1732284841	132	115	255	71	55
1732283640	132	115	255	70	55
1732282439	132	116	255	70	55
1732281238	132	117	255	69	54
1732280037	132	118	255	69	54
1732278836	132	118	255	69	53
1732277635	132	118	255	68	53
1732276434	132	118	255	68	53
1732275233	132	119	255	68	53
1732274032	132	119	255	68	52
1732272831	132	120	255	67	52
1732271630	132	120	255	67	51
1732270429	132	121	255	66	51
1732269228	131	122	255	66	50
1732268027	132	123	255	65	50
1732266826	132	124	255	64	49
1732265625	132	125	255	64	48
1732264424	132	125	255	63	48
1732263223	132	127	255	62	47
1732262022	133	128	255	62	46

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)