APRS Track Direct

My position About ☰

reset

SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790643206	16 Count	787 Count
1790641406	15 Count	751 Count
1790639605	14 Count	709 Count
1790637804	13 Count	664 Count
1790636004	12 Count	617 Count
1790634210	11 Count	581 Count
1790632410	10 Count	534 Count
1790630609	9 Count	491 Count
1790628808	8 Count	461 Count
1790627007	7 Count	419 Count
1790625207	6 Count	368 Count
1790623406	5 Count	316 Count
1790621605	4 Count	267 Count
1790619804	3 Count	216 Count
1790618004	2 Count	160 Count
1790616203	1 Count	96 Count
1790614402	0 Count	0 Count
1790612610	161 Count	954 Count
1790610810	160 Count	921 Count
1790609009	159 Count	891 Count
1790607208	158 Count	867 Count
1790605407	157 Count	842 Count
1790603606	156 Count	814 Count
1790601806	154 Count	786 Count
1790600004	153 Count	756 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)