APRS Track Direct

My position About ☰

reset

N1GMC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N1GMC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1749326299	138	94	255	89	79
1749325398	138	93	255	89	79
1749324497	138	93	255	89	79
1749323596	138	93	255	89	79
1749322694	138	93	255	89	79
1749321793	138	93	255	89	79
1749319991	138	93	255	89	79
1749319090	138	93	255	89	79
1749318188	138	93	255	89	79
1749316386	138	93	255	89	79
1749315485	138	93	255	89	79
1749314584	138	93	255	89	79
1749313683	138	93	255	89	80
1749312782	138	93	255	89	79
1749311880	138	92	255	89	80
1749310979	138	92	255	89	80
1749309177	138	92	255	89	80
1749308275	138	92	255	89	80
1749307375	138	92	255	90	80
1749306473	138	92	255	90	80
1749305573	138	92	255	90	80
1749304671	138	92	255	90	80
1749303770	138	92	255	90	80
1749302868	138	91	255	90	80
1749301066	138	91	255	90	81

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)