APRS Track Direct

My position About ☰

reset

IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762349034	8 Count	376 Count
1762345425	6 Count	293 Count
1762341865	4 Count	216 Count
1762338256	2 Count	137 Count
1762334648	0 Count	40 Count
1762331039	26 Count	959 Count
1762327431	24 Count	879 Count
1762323822	22 Count	785 Count
1762320268	20 Count	706 Count
1762316660	18 Count	634 Count
1762313051	16 Count	572 Count
1762309442	14 Count	499 Count
1762305833	12 Count	435 Count
1762302225	10 Count	366 Count
1762298662	8 Count	301 Count
1762295053	6 Count	238 Count
1762291444	4 Count	166 Count
1762287835	2 Count	96 Count
1762284226	0 Count	33 Count
1762280618	30 Count	980 Count
1762280601	29 Count	979 Count
1762280337	28 Count	977 Count
1762279495	27 Count	962 Count
1762279174	26 Count	957 Count
1762278853	25 Count	951 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)