APRS Track Direct

My position About ☰

reset

SR2SAT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2SAT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753783766	254 Count	618 Count	183 Count
1753781965	245 Count	604 Count	175 Count
1753780164	229 Count	577 Count	160 Count
1753778364	215 Count	551 Count	147 Count
1753774770	199 Count	506 Count	137 Count
1753771169	177 Count	462 Count	117 Count
1753769368	174 Count	455 Count	115 Count
1753767567	172 Count	424 Count	114 Count
1753765767	169 Count	376 Count	112 Count
1753763966	166 Count	364 Count	110 Count
1753762166	163 Count	354 Count	108 Count
1753760364	158 Count	342 Count	104 Count
1753758563	155 Count	331 Count	102 Count
1753754968	145 Count	310 Count	98 Count
1753753168	142 Count	299 Count	96 Count
1753751367	138 Count	287 Count	93 Count
1753749567	135 Count	275 Count	91 Count
1753747766	132 Count	265 Count	89 Count
1753744165	126 Count	247 Count	85 Count
1753742364	123 Count	236 Count	83 Count
1753736962	116 Count	201 Count	79 Count
1753734679	104 Count	186 Count	73 Count
1753731078	95 Count	163 Count	66 Count
1753727483	81 Count	139 Count	58 Count
1753723882	71 Count	114 Count	50 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)