APRS Track Direct

My position About ☰

reset

SQ2SIX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1758183759	30 Count	742 Count	30 Count
1758183159	30 Count	737 Count	30 Count
1758182559	30 Count	733 Count	30 Count
1758181949	30 Count	728 Count	30 Count
1758181349	30 Count	724 Count	30 Count
1758180749	30 Count	720 Count	30 Count
1758180149	30 Count	716 Count	30 Count
1758179549	30 Count	710 Count	30 Count
1758178949	30 Count	708 Count	30 Count
1758178349	30 Count	693 Count	30 Count
1758177749	30 Count	684 Count	30 Count
1758177149	30 Count	672 Count	30 Count
1758176548	30 Count	658 Count	30 Count
1758175948	22 Count	640 Count	22 Count
1758175348	21 Count	633 Count	21 Count
1758174749	21 Count	617 Count	21 Count
1758174149	21 Count	596 Count	21 Count
1758173549	21 Count	588 Count	21 Count
1758172949	21 Count	584 Count	21 Count
1758172349	21 Count	578 Count	21 Count
1758171748	21 Count	576 Count	21 Count
1758171148	21 Count	570 Count	21 Count
1758170548	21 Count	567 Count	21 Count
1758169948	21 Count	564 Count	21 Count
1758169348	21 Count	559 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)