APRS Track Direct

My position About ☰

reset

LA3SHA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LA3SHA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Vin*	Temp*
1750077140	14.63 Volt	19.5 C
1750075340	14.93 Volt	19 C
1750073540	14.78 Volt	18 C
1750071740	13.65 Volt	19 C
1750069940	14.18 Volt	17.5 C
1750068140	13.73 Volt	17 C
1750066340	13.5 Volt	17 C
1750064540	14.18 Volt	15.5 C
1750062740	13.73 Volt	16.5 C
1750060940	13.35 Volt	16 C
1750059140	13.5 Volt	14.5 C
1750057341	13.5 Volt	14.5 C
1750055541	12.83 Volt	14 C
1750053741	13.35 Volt	14 C
1750051941	13.35 Volt	13 C
1750050141	13.2 Volt	12.5 C
1750048341	13.05 Volt	12 C
1750046541	12.9 Volt	12 C
1750044741	12.68 Volt	12 C
1750042941	12.6 Volt	11.5 C
1750041141	12.6 Volt	10 C
1750037541	12.3 Volt	12 C
1750035741	12.6 Volt	11.5 C
1750033941	12.6 Volt	11 C
1750032142	12.6 Volt	12 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)