APRS Track Direct

My position About ☰

reset

NCFPD Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NCFPD. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*
1836274792	137	140	39
1836274489	137	139	39
1836274339	137	140	39
1836274189	137	140	39
1836273890	137	140	39
1770149681	138	139	33
1770149383	137	139	33
1770149080	137	139	33
1770148780	137	139	33
1770148481	137	139	33
1770148180	137	139	33
1770147881	137	139	33
1770147580	137	139	33
1770147280	137	139	33
1770146980	137	139	33
1770146681	137	139	33
1770146381	137	139	33
1770146081	137	139	33
1770145780	138	139	33
1770145481	137	139	33
1770145188	137	139	33
1770144882	137	139	33
1770144581	137	139	33
1770144281	137	139	33
1770143981	137	139	33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)