APRS Track Direct

My position About ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790652292	326 Count	910 Count	258 Count
1790651691	322 Count	896 Count	255 Count
1790651090	316 Count	875 Count	250 Count
1790650490	312 Count	865 Count	247 Count
1790649889	307 Count	847 Count	243 Count
1790649288	300 Count	829 Count	237 Count
1790648687	296 Count	817 Count	234 Count
1790648086	291 Count	804 Count	230 Count
1790647486	285 Count	793 Count	225 Count
1790646885	281 Count	781 Count	222 Count
1790646284	275 Count	766 Count	217 Count
1790645684	270 Count	748 Count	213 Count
1790645082	266 Count	734 Count	210 Count
1790644481	261 Count	721 Count	206 Count
1790643881	253 Count	699 Count	199 Count
1790643280	249 Count	688 Count	196 Count
1790642679	243 Count	672 Count	191 Count
1790642079	238 Count	662 Count	187 Count
1790641478	235 Count	650 Count	185 Count
1790640877	230 Count	639 Count	181 Count
1790640276	225 Count	623 Count	177 Count
1790639676	222 Count	614 Count	175 Count
1790639075	215 Count	593 Count	169 Count
1790638474	211 Count	581 Count	166 Count
1790637874	208 Count	570 Count	164 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)