APRS Track Direct

My position About ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1836274668	165 Count	820 Count
1762297316	99 Count	479 Count
1762295513	98 Count	475 Count
1762293710	97 Count	470 Count
1762291907	96 Count	466 Count
1762290103	95 Count	459 Count
1762288300	94 Count	452 Count
1762286498	93 Count	446 Count
1762284695	92 Count	442 Count
1762282891	91 Count	436 Count
1762281088	90 Count	431 Count
1762279285	89 Count	425 Count
1762277482	88 Count	421 Count
1762275716	87 Count	416 Count
1762273913	86 Count	412 Count
1762272110	85 Count	407 Count
1762270307	84 Count	404 Count
1762268504	83 Count	397 Count
1762266701	82 Count	390 Count
1762264898	81 Count	385 Count
1762263095	80 Count	381 Count
1762261291	79 Count	375 Count
1762259488	78 Count	372 Count
1762257685	77 Count	366 Count
1762255882	76 Count	362 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)