APRS Track Direct

My position About ☰

reset

PY4IG-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY4IG-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1752743601	143	13	999	350	271
1752741800	143	13	999	353	273
1752740000	143	13	999	355	277
1752738199	142	13	999	350	271
1752736398	143	13	999	351	270
1752734598	143	13	999	356	276
1752732797	143	13	999	349	268
1752730997	143	13	999	354	276
1752729196	143	13	999	350	269
1752727396	143	13	999	347	266
1752725595	143	14	999	348	267
1752723795	143	14	999	354	274
1752721994	143	14	999	351	270
1752720193	143	14	999	353	272
1752717752	122	13	999	355	278
1752716668	142	13	999	356	278
1752714867	142	13	999	352	271
1752713067	142	13	999	354	275
1752711266	143	13	999	349	269
1752709466	143	14	999	348	267
1752707665	143	14	999	349	268
1752705864	143	14	999	350	271
1752702263	142	14	999	352	272
1752700463	142	14	999	346	266
1752698662	143	14	999	350	271

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)