APRS Track Direct

My position About ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1758201569	2 Count	59 Count	2 Count
1758199768	64 Count	1003 Count	45 Count
1758197967	60 Count	938 Count	42 Count
1758196166	56 Count	862 Count	39 Count
1758194365	51 Count	803 Count	36 Count
1758192564	47 Count	722 Count	33 Count
1758190763	43 Count	641 Count	31 Count
1758188962	39 Count	586 Count	28 Count
1758187162	34 Count	501 Count	25 Count
1758185360	29 Count	418 Count	21 Count
1758183569	24 Count	356 Count	18 Count
1758181768	20 Count	296 Count	15 Count
1758179967	14 Count	228 Count	11 Count
1758178166	11 Count	146 Count	9 Count
1758176366	4 Count	83 Count	3 Count
1758174565	65 Count	1020 Count	43 Count
1758172764	61 Count	955 Count	40 Count
1758170963	57 Count	886 Count	38 Count
1758169162	52 Count	806 Count	35 Count
1758167362	48 Count	743 Count	32 Count
1758165561	43 Count	690 Count	29 Count
1758163760	40 Count	621 Count	27 Count
1758161968	35 Count	557 Count	24 Count
1758160167	30 Count	487 Count	20 Count
1758158366	25 Count	423 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)