APRS Track Direct

My position About ☰

reset

SR9WXZ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXZ. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx10min*	Vbatt*
1758214785	57 Pkt	13.12 V
1758214184	32 Pkt	13.06 V
1758213197	12 Pkt	13.14 V
1758212596	13 Pkt	13.16 V
1758211395	14 Pkt	13.2 V
1758210795	15 Pkt	13.32 V
1758210185	15 Pkt	13.26 V
1758209584	14 Pkt	13.54 V
1758208981	12 Pkt	13.94 V
1758208380	8 Pkt	14.12 V
1758207779	7 Pkt	14.06 V
1758207178	7 Pkt	14.14 V
1758206577	4 Pkt	14.1 V
1758205977	4 Pkt	14.08 V
1758205376	4 Pkt	14.12 V
1758204776	4 Pkt	14.1 V
1758204176	4 Pkt	14.14 V
1758203575	3 Pkt	14.08 V
1758202975	11 Pkt	14.12 V
1758202372	10 Pkt	14.12 V
1758200558	9 Pkt	14.16 V
1758199958	10 Pkt	14.2 V
1758199357	5 Pkt	14.1 V
1758198757	7 Pkt	14.14 V
1758198156	6 Pkt	14.18 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)