APRS Track Direct

My position About ☰

reset

BVILLE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BVILLE. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274769	128	31	72	42	49
1836274167	128	35	72	41	49
1782493992	145	40	69	42	49
1782493390	145	42	69	42	49
1782492788	145	44	71	42	48
1782492187	143	51	72	40	49
1782491587	143	56	70	41	49
1782490985	145	56	70	42	49
1782490385	144	42	69	41	49
1782489783	143	35	70	41	49
1782489182	136	40	71	42	49
1782488580	144	37	71	42	49
1782487978	144	31	71	41	49
1782487376	144	70	71	42	48
1782486774	144	38	72	68	49
1782486173	149	52	72	41	48
1782485573	144	39	71	70	49
1782484972	146	38	72	42	49
1782484371	142	40	73	41	49
1782483770	140	37	73	41	49
1782483170	130	32	74	41	48
1782482569	130	38	74	41	49
1782481968	132	36	75	41	49
1782481367	140	61	118	42	48
1782480766	138	35	74	42	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)