APRS Track Direct

My position About ☰

reset

E25YYY Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E25YYY. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1836274559	-72 dBm	0.29 V
1836274387	-73 dBm	0.29 V
1762286091	-77 dBm	0.29 V
1762285169	-76 dBm	0.29 V
1762284247	-77 dBm	0.14 V
1762283325	-75 dBm	0.14 V
1762282403	-76 dBm	0.29 V
1762281481	-77 dBm	0.29 V
1762280559	-78 dBm	0.29 V
1762279637	-76 dBm	0.29 V
1762278715	-77 dBm	0.29 V
1762277793	-77 dBm	0.29 V
1762276871	-79 dBm	0.14 V
1762275949	-78 dBm	0.29 V
1762275027	-78 dBm	0.29 V
1762274105	-78 dBm	0.29 V
1762273183	-79 dBm	0.29 V
1762272261	-77 dBm	0.29 V
1762271339	-78 dBm	0.29 V
1762270417	-77 dBm	0.14 V
1762269495	-77 dBm	0.29 V
1762268573	-79 dBm	0.29 V
1762267651	-77 dBm	0.29 V
1762266729	-77 dBm	0.29 V
1762265807	-76 dBm	0.29 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)