APRS Track Direct

My position About ☰

reset

BWMTN Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BWMTN. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Vin*	Rx1h*
1782529827	12.38 Volt	440 Pkt
1782528027	12.38 Volt	450 Pkt
1782526227	12.38 Volt	400 Pkt
1782524427	12.38 Volt	410 Pkt
1782522627	12.38 Volt	460 Pkt
1782520827	12.38 Volt	460 Pkt
1782519028	12.38 Volt	460 Pkt
1782517228	12.38 Volt	530 Pkt
1782515428	12.38 Volt	540 Pkt
1782513628	12.38 Volt	480 Pkt
1782511828	12.38 Volt	450 Pkt
1782510028	12.38 Volt	410 Pkt
1782508228	12.38 Volt	450 Pkt
1782506428	12.38 Volt	580 Pkt
1782504628	12.38 Volt	700 Pkt
1782502828	12.38 Volt	690 Pkt
1782501028	12.38 Volt	620 Pkt
1782499228	12.38 Volt	630 Pkt
1782497428	12.38 Volt	670 Pkt
1782495628	12.38 Volt	580 Pkt
1782493828	12.38 Volt	490 Pkt
1782492028	12.38 Volt	480 Pkt
1782490228	12.38 Volt	530 Pkt
1782488428	12.38 Volt	530 Pkt
1782486628	12.38 Volt	520 Pkt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)