APRS Track Direct

My position About ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1836274631	294 Count	934 Count
1766226032	80 Count	405 Count
1766224231	79 Count	399 Count
1766222431	78 Count	393 Count
1766220638	77 Count	388 Count
1766218837	76 Count	383 Count
1766217037	75 Count	377 Count
1766215236	74 Count	373 Count
1766213435	73 Count	368 Count
1766211635	72 Count	362 Count
1766209834	71 Count	358 Count
1766208033	70 Count	353 Count
1766206232	69 Count	348 Count
1766204432	68 Count	344 Count
1766202631	67 Count	339 Count
1766200830	66 Count	334 Count
1766199037	65 Count	330 Count
1766197237	64 Count	325 Count
1766195436	63 Count	320 Count
1766193635	62 Count	316 Count
1766191834	61 Count	312 Count
1766190034	60 Count	309 Count
1766188233	59 Count	303 Count
1766186432	58 Count	300 Count
1766184632	57 Count	295 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)