APRS Track Direct

My position About ☰

reset

E22DXH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E22DXH-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1753756483	-39 dBm	0.82 V
1753754658	-38 dBm	0.35 V
1753752833	-38 dBm	0.43 V
1753751007	-38 dBm	1.52 V
1753749182	-39 dBm	1.05 V
1753747357	-39 dBm	0.68 V
1753745532	-40 dBm	1.17 V
1753743706	-39 dBm	1.31 V
1753741881	-38 dBm	0.88 V
1753740056	-39 dBm	1 V
1753738231	-39 dBm	0.94 V
1753736405	-39 dBm	0.39 V
1753734580	-38 dBm	1.37 V
1753732755	-39 dBm	0.64 V
1753725454	-39 dBm	1.37 V
1753723629	-38 dBm	1.44 V
1753721803	-39 dBm	1.48 V
1753719978	-39 dBm	0 V
1753718153	-38 dBm	0.57 V
1753716327	-39 dBm	0.64 V
1753714502	-38 dBm	0.74 V
1753712677	-39 dBm	0.76 V
1753710851	-38 dBm	0.59 V
1753709027	-39 dBm	1.17 V
1753707201	-39 dBm	0.49 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)