APRS Track Direct

My position About ☰

reset

VE6NND Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6NND. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790652752	136	30	999	672	506
1790650654	136	30	999	673	507
1790648557	136	31	999	673	505
1790646459	136	30	999	672	506
1790644361	135	30	999	673	507
1790642264	136	30	997	673	507
1790640166	136	30	999	672	504
1790638069	136	31	999	674	507
1790635976	136	31	999	671	505
1790633873	136	31	999	671	504
1790631776	136	31	999	673	507
1790629678	135	30	999	671	506
1790627580	136	31	999	672	507
1790625482	136	30	999	673	507
1790623385	136	30	998	672	506
1790621287	136	30	999	672	506
1790619190	136	30	999	674	508
1790617092	136	30	998	674	508
1790614994	136	30	999	672	505
1790612897	136	30	999	673	505
1790610799	136	30	998	674	508
1790608701	136	30	999	674	507
1790606604	136	30	997	673	505
1790604506	136	30	999	672	506
1790602408	136	30	999	674	509

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)