APRS Track Direct

My position About ☰

reset

9A3SWO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9A3SWO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1754147158	-65 dbm	3.04 V
1754146558	-65 dbm	3.05 V
1754145959	-65 dbm	3.05 V
1754145358	-64 dbm	3.05 V
1754144758	-64 dbm	3.05 V
1754144158	-64 dbm	3.05 V
1754143557	-64 dbm	3.05 V
1754142957	-64 dbm	3.05 V
1754142358	-65 dbm	3.05 V
1754141758	-64 dbm	3.05 V
1754141157	-64 dbm	3.05 V
1754140558	-65 dbm	3.05 V
1754139959	-64 dbm	3.05 V
1754139357	-64 dbm	3.05 V
1754138758	-63 dbm	3.05 V
1754138157	-65 dbm	3.05 V
1754137557	-64 dbm	3.05 V
1754136957	-64 dbm	3.04 V
1754136357	-64 dbm	3.05 V
1754135758	-64 dbm	3.05 V
1754135158	-64 dbm	3.05 V
1754134558	-65 dbm	3.05 V
1754133958	-64 dbm	3.05 V
1754133357	-64 dbm	3.05 V
1754132757	-65 dbm	3.05 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)