APRS Track Direct

My position About ☰

reset

SQ5STR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1750152344	4 Count	204 Count
1750151444	3 Count	177 Count
1750150563	2 Count	131 Count
1750149662	1 Count	95 Count
1750148761	0 Count	60 Count
1750147860	57 Count	1031 Count
1750146959	56 Count	982 Count
1750146058	55 Count	971 Count
1750145157	54 Count	960 Count
1750144256	53 Count	938 Count
1750143358	52 Count	923 Count
1750142455	51 Count	905 Count
1750141554	50 Count	891 Count
1750140653	49 Count	835 Count
1750139752	48 Count	789 Count
1750138851	47 Count	760 Count
1750137950	46 Count	747 Count
1750137049	45 Count	716 Count
1750136149	44 Count	703 Count
1750135248	43 Count	684 Count
1750134347	42 Count	675 Count
1750133446	41 Count	663 Count
1750132545	40 Count	626 Count
1750131644	39 Count	604 Count
1750130744	38 Count	591 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)