APRS Track Direct

My position About ☰

reset

DL4AWI-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL4AWI-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1754175670	-67 dbm	2.98 V
1754174770	-68 dbm	2.98 V
1754173871	-67 dbm	2.98 V
1754172969	-67 dbm	2.98 V
1754172069	-66 dbm	2.98 V
1754171169	-66 dbm	2.98 V
1754170269	-67 dbm	2.98 V
1754168470	-70 dbm	2.98 V
1754167569	-69 dbm	2.98 V
1754166675	-67 dbm	2.98 V
1754165770	-82 dbm	2.98 V
1754164869	-58 dbm	2.98 V
1754163971	-62 dbm	2.98 V
1754163069	-60 dbm	2.98 V
1754162170	-59 dbm	2.98 V
1754160369	-59 dbm	2.98 V
1754159470	-61 dbm	2.98 V
1754158570	-58 dbm	2.98 V
1754157669	-59 dbm	2.98 V
1754156770	-60 dbm	2.98 V
1754155870	-59 dbm	2.98 V
1754154970	-62 dbm	2.98 V
1754154070	-63 dbm	2.98 V
1754153169	-62 dbm	2.98 V
1754152270	-65 dbm	2.98 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)