APRS Track Direct

My position About ☰

reset

VK4RBW-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK4RBW-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750258881	137	255	181	145	122
1750255277	130	255	180	145	122
1750251675	137	255	180	145	121
1750248073	137	255	180	144	121
1750244470	137	255	180	144	121
1750240866	130	255	180	144	121
1750237263	130	255	179	144	120
1750233660	130	255	179	143	120
1750230058	129	255	179	144	120
1750226456	137	255	179	143	119
1750222853	137	255	179	143	120
1750219251	137	255	179	143	120
1750215648	137	255	179	144	118
1750212044	130	255	180	145	120
1750208441	130	255	180	145	122
1750204839	137	255	180	145	122
1750201237	137	255	180	145	120
1750197633	137	255	180	145	120
1750194030	137	255	181	146	121
1750190428	130	255	181	146	121
1750186825	130	255	181	146	121
1750183222	130	255	181	145	121
1750179621	137	255	181	145	120
1750176018	137	255	181	145	120

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)