APRS Track Direct

My position About ☰

reset

N0BCB-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N0BCB-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1753518811	131	69	255	184	150
1753518212	131	69	255	184	150
1753517763	131	69	255	184	149
1753517754	131	70	255	184	149
1753516554	131	70	255	184	149
1753516128	131	70	255	183	149
1753515313	131	70	255	183	149
1753514801	131	70	255	183	149
1753514070	131	70	255	184	149
1753513451	128	70	255	184	149
1753512851	131	70	255	184	149
1753512357	131	70	255	184	149
1753511651	131	70	255	184	149
1753511015	128	70	255	184	149
1753510406	131	70	255	184	149
1753509805	131	70	255	183	149
1753509205	131	71	255	183	149
1753508606	131	72	255	183	149
1753508006	131	72	255	183	148
1753507406	131	73	255	183	148
1753506806	131	74	255	183	148
1753506206	131	75	255	182	147
1753505603	131	75	255	182	147
1753505002	131	76	255	182	147
1753504401	131	76	255	181	146

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)