APRS Track Direct

My position About ☰

reset

HS3ICB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS3ICB-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RSSI*	Voltage*
1774517005	-58 dBm	0.04 V
1774515668	-62 dBm	0.06 V
1774514330	-64 dBm	0.06 V
1774512993	-61 dBm	0.04 V
1774511655	-60 dBm	0.06 V
1774510318	-59 dBm	0.06 V
1774508980	-56 dBm	0.06 V
1774507643	-60 dBm	0.06 V
1774506305	-59 dBm	0.06 V
1774504968	-57 dBm	0.06 V
1774503630	-65 dBm	0.06 V
1774502293	-62 dBm	0.04 V
1774500956	-60 dBm	0.04 V
1774499618	-58 dBm	0.06 V
1774498281	-58 dBm	0.06 V
1774496943	-60 dBm	0.06 V
1774495606	-59 dBm	0.06 V
1774494268	-61 dBm	0.06 V
1774492931	-57 dBm	0.06 V
1774491593	-61 dBm	0.06 V
1774490256	-61 dBm	0.06 V
1774488918	-63 dBm	0.06 V
1774487581	-63 dBm	0.06 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)