APRS Track Direct

My position About ☰

reset

S55YRK-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S55YRK-7. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vcc*	WiFi*
1790660480	11.2 V	-34 dBm
1790659881	11 V	-34 dBm
1790659280	11 V	-33 dBm
1790658681	11.1 V	-34 dBm
1790658081	11.1 V	-34 dBm
1790657421	11.1 V	-33 dBm
1790656821	11.1 V	-34 dBm
1790656221	11 V	-34 dBm
1790655681	11.1 V	-34 dBm
1790655081	11.1 V	-34 dBm
1790654481	11.1 V	-33 dBm
1790653881	11.2 V	-33 dBm
1790653281	11.1 V	-35 dBm
1790652681	11.1 V	-34 dBm
1790652021	11.2 V	-33 dBm
1790651481	11.1 V	-33 dBm
1790650880	11.1 V	-35 dBm
1790650281	11.1 V	-34 dBm
1790649620	11.3 V	-34 dBm
1790649080	11.3 V	-34 dBm
1790648480	11.3 V	-33 dBm
1790647881	11.3 V	-34 dBm
1790647221	11.2 V	-34 dBm
1790646681	11.2 V	-33 dBm
1790646021	11.3 V	-34 dBm

*Used Equation Coefficients:

Vcc: 0, 1, 0

WiFi: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)