APRS Track Direct

My position About ☰

reset

VK2ZAZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2ZAZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	VBAT*
1791759320	-46 dbm	4.83 V
1791757522	-47 dbm	4.82 V
1791755720	-48 dbm	4.83 V
1791753920	-47 dbm	4.85 V
1791752120	-48 dbm	4.83 V
1791750320	-45 dbm	4.83 V
1791748522	-45 dbm	4.84 V
1791746720	-45 dbm	4.82 V
1791744920	-45 dbm	4.82 V
1791743120	-45 dbm	4.83 V
1791741320	-49 dbm	4.83 V
1791739520	-47 dbm	4.85 V
1791737719	-45 dbm	4.83 V
1791735919	-46 dbm	4.82 V
1791734119	-47 dbm	4.83 V
1791732319	-48 dbm	4.83 V
1791730519	-49 dbm	4.84 V
1791728719	-46 dbm	4.83 V
1791726919	-45 dbm	4.86 V
1791725119	-51 dbm	4.83 V
1791723319	-47 dbm	4.83 V
1791721519	-48 dbm	4.82 V
1791719720	-48 dbm	4.82 V
1791717919	-47 dbm	4.83 V
1791716118	-46 dbm	4.83 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)