APRS Track Direct

My position About ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274124	416 Count	45 Count	0 Count
1836273974	415 Count	45 Count	0 Count
1774087317	569 Count	76 Count	52 Count
1774086416	565 Count	76 Count	52 Count
1774085516	559 Count	76 Count	52 Count
1774084615	556 Count	76 Count	52 Count
1774083714	550 Count	76 Count	52 Count
1774082813	547 Count	76 Count	52 Count
1774081913	542 Count	76 Count	52 Count
1774081012	537 Count	76 Count	52 Count
1774080111	532 Count	76 Count	52 Count
1774079210	529 Count	76 Count	52 Count
1774078310	523 Count	76 Count	52 Count
1774077409	518 Count	76 Count	52 Count
1774076524	511 Count	73 Count	50 Count
1774075623	504 Count	69 Count	47 Count
1774074723	495 Count	65 Count	43 Count
1774073822	491 Count	65 Count	43 Count
1774072921	485 Count	65 Count	43 Count
1774072020	482 Count	65 Count	43 Count
1774071120	477 Count	65 Count	43 Count
1774070219	473 Count	65 Count	43 Count
1774069318	467 Count	63 Count	43 Count
1774068418	464 Count	60 Count	43 Count
1774067517	458 Count	60 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)