APRS Track Direct

My position About ☰

reset

HS5SQI-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS5SQI-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	SUN*
1758178005	-35 dBm	1 %
1758177383	-32 dBm	1 %
1758176760	-32 dBm	1 %
1758176137	-32 dBm	1 %
1758175515	-32 dBm	1 %
1758174892	-32 dBm	1 %
1758174269	-34 dBm	0 %
1758173647	-34 dBm	0 %
1758173024	-34 dBm	1 %
1758172401	-34 dBm	1 %
1758171779	-34 dBm	1 %
1758171156	-34 dBm	1 %
1758170533	-34 dBm	1 %
1758169911	-34 dBm	1 %
1758169288	-34 dBm	1 %
1758168665	-34 dBm	1 %
1758168043	-33 dBm	1 %
1758167420	-34 dBm	1 %
1758166798	-34 dBm	1 %
1758166175	-34 dBm	1 %
1758165552	-34 dBm	1 %
1758164930	-34 dBm	1 %
1758164307	-35 dBm	1 %
1758163684	-34 dBm	0 %
1758163062	-35 dBm	1 %

*Used Equation Coefficients:

PM1.0: 0, 1, 0

PM2.5: 0, 1, 0

PM10: 0, 1, 0

RSSI: 0, -1, 0

SUN: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)