APRS Track Direct

My position About ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1790651960	100 Count	597 Count	34 Count
1790650279	98 Count	583 Count	33 Count
1790648598	96 Count	570 Count	32 Count
1790647166	91 Count	559 Count	32 Count
1790645486	89 Count	548 Count	31 Count
1790643805	87 Count	537 Count	30 Count
1790642124	85 Count	526 Count	29 Count
1790640443	84 Count	515 Count	29 Count
1790638763	83 Count	501 Count	29 Count
1790637082	81 Count	491 Count	28 Count
1790635401	79 Count	474 Count	27 Count
1790633720	77 Count	461 Count	26 Count
1790632040	76 Count	451 Count	26 Count
1790630359	74 Count	436 Count	25 Count
1790628678	73 Count	423 Count	25 Count
1790626997	71 Count	413 Count	24 Count
1790625565	66 Count	406 Count	24 Count
1790623885	65 Count	399 Count	24 Count
1790622204	63 Count	391 Count	23 Count
1790620523	62 Count	379 Count	23 Count
1790618843	60 Count	367 Count	22 Count
1790617162	59 Count	358 Count	22 Count
1790615481	58 Count	351 Count	22 Count
1790613800	57 Count	339 Count	22 Count
1790612119	56 Count	330 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)