APRS Track Direct

My position About ☰

reset

ERIDGE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ERIDGE. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790626891	132	23	70	41	48
1790626275	132	21	70	41	48
1790625657	132	18	71	41	48
1790625046	132	21	69	41	48
1790624429	132	25	98	42	48
1790623810	130	26	70	41	48
1790623191	130	20	71	41	48
1790622569	130	69	70	41	48
1790621955	130	21	70	41	48
1790621339	130	22	70	41	48
1790620722	130	22	71	41	48
1790620105	130	18	70	41	48
1790619491	129	24	63	41	48
1790618865	132	21	69	41	48
1790618252	129	19	70	41	48
1790618252	-	-	-	-	-
1790617637	129	20	70	41	48
1790617020	129	25	70	41	48
1790616401	129	63	122	42	48
1790615782	129	20	69	41	48
1790615163	129	21	70	41	48
1790614548	130	21	68	41	48
1790613929	130	20	70	41	48
1790613309	130	20	69	41	48
1790612692	129	25	64	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)