APRS Track Direct

My position About ☰

reset

IDIOTV Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IDIOTV. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732309956	173	192	86	46	73
1732307567	171	190	87	46	73
1732305155	177	196	88	46	73
1732302772	172	191	88	47	73
1732300355	172	191	88	46	73
1732297960	173	192	87	46	74
1732295555	173	191	88	46	73
1732293159	175	194	88	46	73
1732290760	165	184	85	45	74
1732288355	165	184	84	45	74
1732285959	165	184	85	45	74
1732283555	165	184	85	45	74
1732281157	165	184	85	45	73
1732278763	165	184	85	45	73
1732276361	165	184	85	45	73
1732273956	165	184	85	45	73
1732271562	165	184	85	45	74
1732269167	165	184	85	45	73
1732266755	166	184	85	45	72
1732264359	166	185	85	45	72
1732261960	166	185	85	45	72
1732259554	166	185	85	45	72
1732257165	167	185	86	46	73
1732254754	167	186	85	45	72
1732252355	167	186	86	46	72

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)