APRS Track Direct

My position About ☰

reset

KQ6DI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	DC*	PC Board*	Ambient*	upper*	lower*
1836274440	268	774	713	782	778
1836274290	265	784	717	777	774
1836274142	265	767	709	784	779
1774144264	243	808	724	940	904
1774143664	292	794	712	956	911
1774143364	292	788	709	964	914
1774143064	292	795	715	974	922
1774142463	262	818	735	992	941
1774141863	270	818	733	1005	952
1774141566	265	816	732	1010	954
1774141263	270	814	728	1016	959
1774140663	262	800	717	1031	966
1774140064	267	795	716	1050	975
1774139765	258	803	724	1060	982
1774139464	243	814	736	1076	995
1774138863	270	822	737	1091	998
1774138264	267	817	733	1097	994
1774137964	267	814	730	1096	988
1774137664	317	804	720	1106	994
1774137063	318	800	720	1114	997
1774136463	324	820	738	1129	1012
1774136166	305	824	741	1134	1019
1774135863	326	823	738	1132	1010
1774135263	309	817	733	1141	1013
1774134663	305	803	723	1138	1005

*Used Equation Coefficients:

DC: 0, 1, 0

PC Board: 0, 1, 0

Ambient: 0, 1, 0

upper: 0, 1, 0

lower: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)