APRS Track Direct

My position About ☰

reset

WAREAG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WAREAG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274372	13.02	59.1	75	44	115
1836274222	13.02	59.1	75	44	115
1774127820	14.16	52	74	43	114
1774127220	14.16	52	74	43	112
1774126620	14.23	52	74	43	114
1774126022	14.16	52	74	43	116
1774125420	14.23	52	74	43	114
1774124822	14.16	48.5	74	43	116
1774124220	14.23	52	74	43	114
1774123621	14.16	52	74	43	116
1774123021	14.29	52	74	43	114
1774122421	14.23	52	74	43	115
1774121821	14.23	52	74	43	114
1774121220	14.23	52	74	43	114
1774120621	14.29	48.5	74	43	114
1774120021	14.23	48.5	74	43	112
1774119421	14.29	48.5	73	43	114
1774118824	14.23	52	74	43	115
1774118220	14.1	48.5	73	43	115
1774117621	14.23	48.5	73	43	114
1774117023	14.16	48.5	73	43	116
1774116421	14.73	48.5	73	42	113
1774115821	14.29	48.5	73	43	112
1774115221	14.16	48.5	73	43	114
1774114621	14.99	48.5	73	43	114

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)