APRS Track Direct

My position About ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786744924	932 Count	530 Count	289 Count
1786742997	930 Count	530 Count	289 Count
1786741070	928 Count	530 Count	289 Count
1786739143	926 Count	530 Count	289 Count
1786737217	923 Count	529 Count	288 Count
1786735289	921 Count	529 Count	288 Count
1786733362	918 Count	528 Count	287 Count
1786731435	916 Count	527 Count	287 Count
1786729509	914 Count	527 Count	287 Count
1786727582	912 Count	527 Count	287 Count
1786725655	893 Count	510 Count	270 Count
1786725247	878 Count	496 Count	256 Count
1786723320	876 Count	496 Count	256 Count
1786721394	874 Count	496 Count	256 Count
1786719467	872 Count	496 Count	256 Count
1786717540	870 Count	496 Count	256 Count
1786715613	868 Count	496 Count	256 Count
1786713687	840 Count	470 Count	230 Count
1786711760	838 Count	469 Count	230 Count
1786709833	836 Count	469 Count	230 Count
1786707906	834 Count	469 Count	230 Count
1786705980	832 Count	469 Count	230 Count
1786704053	830 Count	469 Count	230 Count
1786703647	829 Count	469 Count	230 Count
1786701720	827 Count	469 Count	230 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)