APRS Track Direct

My position About ☰

reset

PY5UHF-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5UHF-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790629991	125	94	94	128	129
1790629686	125	120	122	128	128
1790629546	124	128	128	127	127
1790629246	125	129	129	128	129
1790627142	126	147	147	129	130
1790626832	126	146	146	129	130
1790626521	127	147	147	129	130
1790626217	128	149	148	131	131
1790625866	137	177	176	140	140
1790625260	133	187	186	137	137
1790624957	137	197	196	140	140
1790624356	136	198	197	139	140
1790623754	137	199	199	140	140
1790623107	137	203	202	140	140
1790622806	137	198	198	140	140
1790621556	135	193	193	138	138
1790621254	135	203	203	138	138
1790620954	136	203	203	139	139
1790620652	136	205	204	139	139
1790620630	-	-	-	-	-
1790620352	135	205	204	139	139
1790620051	135	206	205	139	139
1790619451	136	206	205	139	140
1790618548	135	204	204	137	138
1790618250	135	205	204	138	138

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)