APRS Track Direct

My position About ☰

reset

WR4AGC-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WR4AGC-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774129084	231	37	26	20	113
1774127284	230	37	26	20	113
1774125484	231	38	27	20	113
1774123684	230	38	27	20	113
1774121884	230	37	26	20	113
1774120084	231	37	26	20	113
1774118284	230	37	26	20	113
1774116484	230	37	26	20	113
1774114684	230	37	26	20	113
1774112884	230	37	26	20	113
1774111084	230	37	26	20	113
1774109284	230	37	26	20	113
1774107485	230	37	27	20	113
1774105684	230	37	26	20	113
1774103885	230	37	26	20	112
1774098485	230	37	26	20	113
1774094885	230	37	27	20	113
1774093084	230	37	26	20	113
1774091285	230	37	26	20	113
1774089484	230	37	26	20	113
1774087685	230	37	26	20	112
1774085885	230	37	26	20	113
1774084085	230	37	26	20	113
1774082285	230	37	26	20	113
1774080485	230	37	26	20	112

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)