APRS Track Direct

My position About ☰

reset

EB5KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790660800	10 Count	738 Count
1790658997	9 Count	689 Count
1790657194	8 Count	616 Count
1790655391	7 Count	519 Count
1790653588	6 Count	458 Count
1790651785	5 Count	396 Count
1790649982	4 Count	325 Count
1790648178	3 Count	255 Count
1790646409	2 Count	196 Count
1790644606	1 Count	133 Count
1790642803	0 Count	73 Count
1790641000	14 Count	1032 Count
1790639197	13 Count	971 Count
1790637394	12 Count	906 Count
1790635591	11 Count	841 Count
1790633788	10 Count	784 Count
1790631984	9 Count	706 Count
1790630181	8 Count	634 Count
1790628378	7 Count	564 Count
1790626575	6 Count	489 Count
1790624808	5 Count	410 Count
1790623005	4 Count	330 Count
1790621202	3 Count	260 Count
1790619399	2 Count	198 Count
1790617596	1 Count	129 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)