APRS Track Direct

My position About ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274840	151 Count	457 Count	3 Count
1836274239	148 Count	452 Count	3 Count
1774087117	154 Count	852 Count	41 Count
1774086516	153 Count	846 Count	41 Count
1774085915	150 Count	834 Count	39 Count
1774085314	149 Count	825 Count	39 Count
1774084714	148 Count	819 Count	39 Count
1774084113	147 Count	812 Count	39 Count
1774083512	146 Count	802 Count	39 Count
1774082911	145 Count	798 Count	39 Count
1774082311	144 Count	791 Count	39 Count
1774081710	143 Count	783 Count	39 Count
1774081109	142 Count	778 Count	39 Count
1774080508	141 Count	772 Count	39 Count
1774079908	140 Count	765 Count	39 Count
1774079307	139 Count	760 Count	39 Count
1774078706	138 Count	754 Count	39 Count
1774078105	137 Count	747 Count	39 Count
1774077505	136 Count	735 Count	39 Count
1774076905	132 Count	717 Count	36 Count
1774076303	123 Count	689 Count	28 Count
1774075702	122 Count	686 Count	28 Count
1774075102	121 Count	680 Count	28 Count
1774074501	120 Count	671 Count	28 Count
1774073900	119 Count	666 Count	28 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)