APRS Track Direct

My position About ☰

reset

OE5MIL-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE5MIL-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Vin*	Temp*
1732306324	13.05 Volt	-4.5 C
1732305124	13.05 Volt	-4.5 C
1732303923	13.05 Volt	-4.5 C
1732301519	13.13 Volt	-4.5 C
1732300318	13.13 Volt	-4 C
1732299117	13.13 Volt	-4 C
1732297916	13.13 Volt	-4 C
1732295513	13.13 Volt	-4 C
1732294312	13.2 Volt	-4 C
1732293111	13.2 Volt	-4 C
1732290709	13.2 Volt	-4 C
1732289508	13.28 Volt	-4 C
1732288307	13.35 Volt	-4 C
1732287105	13.43 Volt	-3.5 C
1732284703	13.65 Volt	-3.5 C
1732283506	13.73 Volt	-3.5 C
1732279899	14.03 Volt	-3.5 C
1732271490	13.95 Volt	-3 C
1732270289	13.65 Volt	-3 C
1732269088	13.5 Volt	-3 C
1732267887	13.5 Volt	-3 C
1732266686	13.43 Volt	-3 C
1732265487	13.2 Volt	-3 C
1732264284	13.05 Volt	-3 C
1732260680	12.98 Volt	-3 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)