APRS Track Direct

My position About ☰

reset

JA2YQQ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JA2YQQ-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732266432	120	75	255	94	97
1732265531	120	75	255	93	97
1732264630	120	75	255	93	96
1732263729	120	76	255	93	96
1732262828	120	76	255	92	96
1732261927	120	77	255	92	95
1732261026	120	78	255	92	95
1732260125	120	79	255	91	94
1732259224	120	81	255	90	93
1732258322	120	82	255	90	92
1732257421	120	83	255	89	91
1732256520	120	84	255	88	90
1732255619	120	86	255	87	89
1732254718	120	89	255	86	88
1732253817	120	90	255	84	86
1732252916	120	92	255	83	85
1732252015	120	94	255	83	84
1732251114	120	94	255	83	84
1732250213	120	94	255	83	84
1732249311	120	94	255	83	84
1732248410	120	95	255	82	83
1732247509	120	95	255	82	83
1732246608	120	96	255	81	83
1732245707	120	96	255	81	82
1732244806	120	96	255	82	83

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)