APRS Track Direct

My position About ☰

reset

W4KEL-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-7. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1836274782	11.84	28.07
1778020353	13.36	39.32
1778018306	13.51	40.3
1778016259	13.54	40.3
1778014212	13.68	40.79
1778012166	13.71	41.28
1778010119	13.71	40.79
1778008072	13.74	40.3
1778006025	13.8	39.32
1778003979	13.83	37.85
1778001934	13.89	36.39
1777999889	13.89	34.92
1777997842	13.92	32.96
1777995798	13.98	30.52
1777993755	13.98	27.59
1777991713	13.95	24.16
1777989672	13.92	21.72
1777987630	13.89	20.74
1777985589	13.45	19.76
1777983548	13.48	18.78
1777981507	13.48	18.29
1777979466	13.39	18.29
1777977426	13.39	18.29
1777975385	13.39	18.78
1777973344	13.39	19.27

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.489, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)