APRS Track Direct

My position About ☰

reset

MKGBRD Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MKGBRD. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274194	13.2	9	75	45	117
1774118770	14.9	-2	73	43	117
1774116970	14.6	-4	73	43	117
1774115170	15	0	73	43	116
1774113372	13.6	-4	72	43	117
1774111571	13.3	-6	72	42	117
1774109769	13.1	-8	71	42	116
1774107969	13.1	-10	71	42	116
1774106169	13.1	-10	71	42	116
1774104369	13	-10	71	42	116
1774102569	13	-10	71	42	117
1774098970	13	-8	71	42	117
1774097168	13	-8	71	42	116
1774095368	13.1	-8	71	42	116
1774093568	13.1	-8	71	42	116
1774091768	13.1	-8	71	42	116
1774089968	13.1	-8	72	42	114
1774086368	13.1	-8	71	42	116
1774084568	13.1	-8	71	42	117
1774082768	13.2	-6	72	42	116
1774080968	13.2	-8	71	42	116
1774079168	13.2	-6	72	42	117
1774077368	13.2	-6	72	42	116
1774075571	13.2	-6	72	42	117
1774073768	13.2	-6	72	42	117

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)