APRS Track Direct

My position About ☰

reset

SR9WXJ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXJ. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Rx10min*	Vbatt*
1750075396	39 Pkt	11.78 V
1750074793	36 Pkt	12.16 V
1750074190	36 Pkt	12.3 V
1750074190	36 Pkt	12.3 V
1750073587	53 Pkt	12.52 V
1750072985	36 Pkt	12.6 V
1750072381	30 Pkt	12.7 V
1750071779	36 Pkt	12.62 V
1750071176	39 Pkt	12.72 V
1750070573	42 Pkt	12.76 V
1750069957	41 Pkt	12.76 V
1750069354	48 Pkt	12.8 V
1750068751	36 Pkt	12.84 V
1750067545	42 Pkt	12.92 V
1750067545	42 Pkt	12.92 V
1750066942	47 Pkt	12.9 V
1750066339	53 Pkt	13.22 V
1750066339	53 Pkt	13.22 V
1750065737	36 Pkt	13 V
1750065133	37 Pkt	13.1 V
1750064530	33 Pkt	12.84 V
1750064530	33 Pkt	12.84 V
1750063928	42 Pkt	12.98 V
1750063325	46 Pkt	12.98 V
1750062722	58 Pkt	12.98 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)