APRS Track Direct

My position About ☰

reset

SQ2LXR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2LXR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1763307457	405 Count	844 Count	147 Count
1763307396	404 Count	843 Count	147 Count
1763307335	403 Count	842 Count	147 Count
1763307275	401 Count	839 Count	146 Count
1763307214	400 Count	837 Count	146 Count
1763307153	399 Count	835 Count	146 Count
1763307093	398 Count	834 Count	146 Count
1763307032	396 Count	831 Count	145 Count
1763306971	395 Count	830 Count	145 Count
1763306910	394 Count	829 Count	145 Count
1763306849	392 Count	826 Count	144 Count
1763306789	391 Count	825 Count	144 Count
1763306728	390 Count	823 Count	144 Count
1763306667	388 Count	819 Count	143 Count
1763306606	386 Count	813 Count	142 Count
1763306546	385 Count	811 Count	142 Count
1763306485	384 Count	810 Count	142 Count
1763306424	383 Count	809 Count	142 Count
1763306363	382 Count	807 Count	142 Count
1763306302	381 Count	806 Count	142 Count
1763306241	380 Count	804 Count	142 Count
1763306181	379 Count	803 Count	142 Count
1763306120	377 Count	797 Count	141 Count
1763306059	375 Count	794 Count	140 Count
1763305998	374 Count	791 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)