APRS Track Direct

My position About ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753696073	703 Count	786 Count	675 Count
1753694273	673 Count	753 Count	646 Count
1753692472	649 Count	726 Count	623 Count
1753690671	601 Count	676 Count	576 Count
1753688871	561 Count	633 Count	537 Count
1753687070	540 Count	611 Count	517 Count
1753685270	527 Count	595 Count	505 Count
1753683469	478 Count	544 Count	457 Count
1753681669	459 Count	522 Count	439 Count
1753679868	441 Count	501 Count	422 Count
1753678068	407 Count	464 Count	389 Count
1753667263	282 Count	320 Count	270 Count
1753665462	263 Count	299 Count	252 Count
1753663662	245 Count	279 Count	235 Count
1753661861	223 Count	254 Count	214 Count
1753660061	202 Count	229 Count	194 Count
1753658260	170 Count	194 Count	163 Count
1753656460	150 Count	171 Count	144 Count
1753654659	130 Count	149 Count	125 Count
1753651058	87 Count	101 Count	84 Count
1753649257	69 Count	80 Count	67 Count
1753647457	52 Count	60 Count	51 Count
1753645656	18 Count	24 Count	18 Count
1753643856	873 Count	1027 Count	819 Count
1753642055	838 Count	986 Count	785 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)